The reviews are automatic translation.
On 2016-07-05 13:27:35
Craftsmanship is necessary to make the spoke screws. After practicing dozens of unnecessary spokes, it became possible to make satisfying going screws. I hope the crossovers are a bit cheaper.
On 2015-10-05 13:51:41
I think whether the cost can be lowered a little more.
On 2015-01-16 10:58:40
Since these days there are not many places to sell spokes with roses, we purchase long items together, cut it to the required length, and cut the threads of rolling with this. I make around 20 at a time, but I can create it without any particular difficulty. I do it because I am doing it as a hobby, but I have not asked for efficiency, but if you use more cutting oil and do not clog chips as much as possible, the rotation of the steering wheel seems to be smooth.
On 2014-12-26 12:27:11
Since the blade is also not cheap at all, it is better not to use it for making stainless steel spokes. If you make as many as 200, your teeth become sweet and you can not use it. Let's use it exclusively for iron spoke production. There are tricks in how to use, it is not good just by passing it once. Shall shallowly cut the groove at the first time, finish by cutting the deep groove at the second time, it will not fail. Adjust the depth of the groove by actually testing it and you should punch it so as not to forget the proper position. There is compatibility with cutting oil, and if compatibility is bad, pitch of groove cutting becomes small finely. Still if you adjust the groove adjustment nut it will often work, so let's make it through craftsmanship without giving up.
Spoke threading work
On 2013-02-15 16:03:38
I was adjusting to # 14, but it was thicker than that.
Create spokes for small cars
On 2012-11-29 12:59:40
I used it for the first time to build a wheel. However, it is quite difficult. Since it is not possible to mount threads easily at one time, it must be done at least twice. It would be nice to make several pieces, but if you make the front wheel and the back wheel, you have to make a considerable number. I got tired of turning by hand, I removed the handle and thrust the electric screwdriver.