The reviews are automatic translation.
At the time of maintenance of the machine
On 2016-08-12 09:46:52
After going to the M4 tap, you slip even tighten until the end the thick better. Thin person does not enter even try to put in the back. Once it is inserted from the spread to remove the cap, now finally available. Ratchet did not even attached to the thought that has been attached. I buy on the net is is no doubt better to only when you know the model number.
On 2016-06-20 16:58:17
So if you are firm, it is a good product.
We arrived immediately.
We used an aluminum plate having a thickness of 3 mm to cut the M3 screws.
On 2014-09-18 13:43:28
I purchased along with the tap, but arrived the day after the order, was able to easily screw off. Monotarou Mr. survives very earliest work.
On 2014-06-26 20:59:56
It is what you are quite firm. I think that or not is how to use that bad break immediately.
Screw hole machining (tapping)
On 2014-05-08 10:16:38
Chuck is in a two-stage, good because it is possible to match the tap fixed diameter.
On 2014-02-24 22:08:41
The handle is in too short, making it was not good enough
Fast break did not quite make sense, was good have to buy
In their applications, the lowest
On 2013-10-19 13:04:58
Threaded to the iron parts
On 2013-08-27 23:23:26
For the threaded of the M5, I bought the K-438A.
There is also that you have used in conjunction with MonotaRO made tapping spray, we were able threaded processing without anxiety.