The reviews are automatic translation.
Processed and used for the metal gasket
On 2016-09-29 16:49:59
We use by processing the gasket of manufacturing equipment.
So I do not use only a small amount has been very useful.
Purchase for heat dissipation
On 2015-10-29 19:38:44
It's just copper and outstanding heat dissipation. It also has good processability, and it also attracts heat conduction seals well.
Protection of products such as caul plates and floor boards.
On 2015-03-08 13:24:07
I put it in a box of cardboard and it was packed quite strictly. Regarding the quality of the copperplate, there is no problem for its purpose of use.
Opening a hole, Radish-radisher, handmade by a bell
On 2015-02-28 14:48:52
It is easy to process and satisfactory.
For cutting after welding
On 2014-09-09 13:33:00
I bought a thin board, but I sent it as naked in corrugated cards as it was, and I was sent in only packing which had put in a piece of paper that was sharp. It is bent from the corner to about 8 cm and it is extremely troubling. It was an easy way of reinforcing that you could easily imagine that it was moving in cardboard and bent during transport. I think that the result is quite different even at least by inserting it in board corrugated boards but I think that it can happen again as long as you see the same thing happening several years ago. If it can be improved, it may be meaningful to write like this, but from now on I felt that I had to pay attention to what I had planned so far and have to order.
It is packed firmly
On 2013-11-16 23:42:53
It is packed with the cardboard cardboard and bubble wrap.
I will cut out a few pieces from now and use it by etching.
On 2012-08-03 16:14:51
Although there are no scratches on packaging, there are bends in 5 places such as four corners on the board. In addition, there are six places of dents and scratches other than the four corners and sides. Since dimensions are ordered with some margin, bends such as corners can be avoided, but scratches outside the edges of the board are in trouble. In the case of a thin sheet, it is only necessary to polish a hair line or the like, but dents and the like are difficult to beat out depending on the size, and only to throw away that part. If there are things more than minor scratches such as scratch scratches, I would like you to specify in advance.
On 2012-04-13 15:48:12
The end of the flat plate was packed in a bent state. You can see the scratchy work of packing thin flat plates without support such as cardboard. Monotaro should prepare for cheap and bad, and use it.