The reviews are automatic translation.
Automobile sheet metal
On 2016-03-12 10:50:59
I thought whether it could be used for a recess without a bending angle, never to bring out the stud welding, but was there a variation in the product quality, or it was peeling off as well as another review of the original or low, it was broken. The remaining metal fittings were processed and treated with hot bond. If it is possible to finish with hundreds of yen at the home center if it is metal fittings · · ·
Sheet metal withdrawal
On 2015-11-10 18:39:21
I bought an expensive BP - 25 so as not to break, but it was not stable at all because workability was totally unstable, as it was easy to get close contact, broken apart from the root, pulled in a whim, and so on It was a product that I felt very expensive.
On 2015-08-29 09:56:02
I pulled it, I took it from the pedestal. There is a deficiency in the fixing method of resin and pedestal. I think that I can not use it.
Car dent pull
On 2015-08-03 12:15:26
I thought that I should pull in the dent in the rear gate of the caravan, but I think that the temperature is high, but I have torn down before the point of adhesion. I think that it was partly due to using a slide hammer. I think I got it because I pulled it with the thinnest type. It is better to make it a little bigger type or gluing two and slowly pull it. I think that you can try various sizes if the price is cheap. One hundreds of yen is the limit.
Repair of automobile body
On 2015-02-27 20:12:31
Most products can be repaired with this product and slide hammer.
On 2014-11-12 14:40:21
I pulled my strength and I got a root. has no meaning.
Light dent repair of car body
On 2014-03-12 14:08:27
I welded and worked with a slide hammer, but it broke apart with no resistance in the first shot. I was also careful about the angle and pulled straight, but it does not become usable at all. 3000 yen flew in a while. I am very dissatisfied.
Pull out the motorcycle tank
On 2014-03-03 15:38:35
Besides break it
On 2014-02-02 23:40:49
It does not become usable. With a force of about 50%, it was able to be seen cleanly from the root with the first use. I do not recommend 120%.
To dents in motorcycle tank
On 2013-06-21 14:39:10
I peeled off the paint, warmed the tank with a heat gun, stuck this pooler and cooled with water and pulled with a slide hammer after 2 minutes but the puller could not be removed and it was not possible to make a dent, but the same result was done