- Cutting Time Elongation (%)
- Hardness (Durometer A)
- Tensile Strength (MPa)
- Heat-Resistant Temperature (deg C)
- -30 to +150
- Specific Gravity
- JIS Standard
- Rubber sheet
- Silicon hardness 50
* Products that meet your criteria are shown in table below.
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
2 Customer Reviews
The reviews are automatic translation.
Hole filling occurred in the joint rubber sheet
On 2015-08-21 16:17:14
I had adequate elasticity and I could cut it well even with a cutter knife.
I use it to receive a cutter blade
On 2015-04-14 16:47:09
Up to now it was 8 mm, but the thickness is a little thin and purchased 10 mm this time. I am satisfied that I can use it without any problems. Ideally speaking, 9 mm is the best.