The reviews are automatic translation.
Bamboo, drilling of wood
On 2017-07-31 14:57:06
When digging a deep hole from both sides of the board, the cut member can not be attached to the hole saw.
Drilling of plywood
On 2017-07-03 08:07:43
Cutting blades can be replaced as necessary and easily mounted
It is very useful.
Although it is recommended to use it at low speed from the viewpoint of prevention of falling off of the blade
There is no problem if it cuts little by little.
Especially if you work carefully at the first stage, it will be a beautiful finish.
How to write "Drill part bent" how it will be,
I would like to hear it in reverse.
Although drills can be exchanged, it is possible to replace the drill with a leaf net
Please check it occasionally whether hole screws are loose or not.
Drilling of 15 mm Lauan plywood
On 2017-05-11 22:19:33
I used it to cut the lauan plywood with the wallpaper attached, but if I cut it from the wallpaper side, the side visible to the table did not come out of bali, the wallpaper was not torn, it was well broke. It is enough for hobby.
Drilling in veneer
On 2017-01-12 15:05:15
Although the installation of the blade is a little hard, it is convenient to be installed without tools. I feel that the drill part is weak, and when I use it for a day it seems slightly bent.
Meter cowl drilling
On 2016-10-05 16:10:29
I bought it because it was only this number of pies match, but I am very satisfied.
Drilling of plaque
On 2016-04-27 15:53:19
Hole diameter OK. It is convenient if there is one in one factory.
It is used for pipe drilling of vanities.
On 2015-11-02 20:35:45
It is light and strong. I used it to open a hole of about 7 cm on a thin plywood board. I could open it so much. I think that it is a very good product. I hope to last longer.
To make a hole in the wooden top board
On 2014-01-18 09:39:06
I think that the sharpness of the blade is impeccable, but if you use it with impact, you will inevitably have a blow, so the hole spreads somewhat! Is it? Although it is written as work with low rotation as possible, it is quite difficult. Since the blade easily disengaged, it was often taken during work.
Drilling to Lauan plywood 18 mm
On 2013-04-06 11:12:09
Since there was a report by the other person that the axis breaks, I was slowly and carefully thought that it would be bad if the impact of the driver worked many times but the impact worked deeply as I cut it in again. As I was worried about breaking, I tried to turn it at high speed with a driver without impact mode. I am sorry that there is "for impact" in the product name, but in my case I could safely use it with the impact mode OFF or non-impact driver.
Drilling 50 π in the lumber core board
On 2012-09-19 16:25:12
Hexagonal axis broke at about 20 hole drilling, the blade is solid and it is considerable convenience if it can not be broken. Other things that I repurchased not to break axially were too bad.