The reviews are automatic translation.
Mainly solar power certificate management
On 2016-04-18 16:54:18
It is good very used without permission in a small
Bike battery charging, the measurement of the discharge state
On 2015-09-03 11:53:23
Than conventional current measurement, it is useful in the expected music. However, there are bikes of wiring (wire harness) is also dense while gradually finely, so also there is also unmeasurable places I wanted to measure. It is I wish if somehow, hope there is that.
Current measurement of automotive wiring
On 2015-03-13 22:09:31
Ease of use at narrow compared to other products because the body is a large diameter thin clamp part in a small is the best. If there is a 0 point adjustment of the press of a button rather than a variable resistor type if you think better.
I use the inspection of the electrical system in the chief electrical engineer.
On 2014-03-11 12:04:11
Because the clamp easily be measured, it uses conveniently.
Very convenient since direct current can be measured to the charging current of the solar battery and the input current of the inverter Even though the terminal has been removed and the ammeter was connected until now it is OK to squeeze with the clamp meter
On 2012-02-28 15:20:24
Although I have a couple of things that can measure AC, I did not know that DC can be measured, so I looked at the catalog and found it very conveniently purchased and purchased immediately Shamefully I can measure DC I did not know that the clamp meter is on sale Mainly measuring the charging current of each DCAC inverter input current and a dozen batteries connected in parallel
Confirm that there is no load current during equipment removal work
On 2012-02-15 14:57:45
The resolution is 0.1 A. Although it is not written in the instruction manual, it seems that it is better to think about the measurement of small current (1 ~ 2A or less) like using SANWA 's clamp meter DCL 30 DR as being outside the accuracy guarantee. It is good to be compact and lightweight.
Used to confirm that there is no load current during equipment removal work
On 2012-02-13 01:31:56
Both AC and DC have resolution of 0.1A. Although it is not written in the product manual, as with the clamp meter DCL30DR of SANWA, it seems better to interpret the measured value less than the small current (1 to 2A) as being not guaranteed accuracy. I think that it is advantageous to be compact and lightweight.
To the current check in the small control panel, in a narrow place.
On 2011-07-24 23:04:23
I bought it at the time of special price. With this price, there was not a compact thing of both AC and DC, so it is lucky compact and easy to use