The reviews are automatic translation.
Replacing the valve of a motorcycle
On 2018-02-22 07:37:29
I used it to replace the valve of the scoater's wheel. The function is fine, but the quality is low. There is no problem if you think from the price.
Replacement of air valve at tire change
On 2017-12-05 07:47:03
Rubber packing in the air valve cap is misaligned and air is coming out
Tire exchange on your own
On 2016-04-21 20:13:21
Although it replaced with tire change, it leaked from the rubber packing on the back side as the other person wrote the air leaked in about two weeks. Because replacement is troublesome, we replenish the air every time we ride.
On 2015-12-15 21:43:55
The aluminum material was soft and the packing was thick because it was cheap, and it tried to enter it while pushing it easily, it entered diagonally easily, and I licked the screw very easily. No matter how many times I did it, I was not good, I bought two and made two of them useless.
It is the purchase of the third one.
On 2015-04-29 09:10:26
I bought it in the motorbike shop before, but since it is cheap, I bought it this time with Monotaro. I think that it is considerably cheaper than other manufacturers if this price is 2 pieces set. I am using it for the purpose of dressing up, so it answers enough expectations. However, the finish of the screw thread portion of the cap and the aluminum ground is a little rough, and it seems to lick the thread mountain if not careful. Also, although other people point out air leakage, if you install it by attaching a silicone bond for water circulation to the rubber packing part on the back side when installing, the problem can be solved. Since it is a rubber packing, even when tightening the nut, you can use it without any problems if you moderate it in a reasonable place.
Tubeless tire repair
On 2014-10-30 20:25:06
It was attached to the rear tire of the cabina 90, it was a type that tightened the nut from the outside, so it was very easy to install, the durability of the rubber of the packing is a little worrisome, but it will not be a problem until the next tire change · I think that the appearance is beautiful and satisfied.
In the air valve of Iku
On 2013-08-31 17:50:29
There is no need to remove the whole tire, the installation is simple, the workability is good.
Replacement from snap-in valve
On 2012-01-25 18:48:53
Molding failure at the end of the valve, and air leakage. Anyway product accuracy is low! I do not buy any more hard to put in air.
Considering the appearance when exchanging the tire, replace it with this valve.
On 2012-01-04 14:42:06
One out of two is defective! (Front wheel) Initially it was a bad muscle, and I did not replace it with a new mussel. I do not know whether it is defective unless you attach a valve. What to do? The desorption fee for a diamond is \ 3000 only before exchanging to normal, even ¥ 1500, but then it is nothing good to look at anything. Then, you buy another set? (You do not want to buy it at all), after all, you will pay wages as many as 3,000 yen in the eventual exchange place. So you only have to buy the items of the store when exchanging tires. I was made to study. (In that case you can not get the labor charge even if it is defective?)