Buy more than* S$200* and get FREE SHIPPING
Due to the national holidays as Golden Week, we will close 2018/4/28~2018/4/30 and 2018/5/3~2018/5/6.
This may cause delays with our responses. Thank you for your understanding.
The wiring of the cell starter switch was different from the manual. When it is ON, it is written as "red - black / red" when it is ON, but the cell actually turned around with "black / red - blue". This resulted in a considerable delay in the work, and I felt the actual harm that it would not make it in time for delivery. It seems to be a product whose quality control and inspection are being despised. I wish for good faith correspondence.
There was a disconnection in the wiring. Originally returned and refunded, I wonder that they should be exchanged, but since we have to use the motorcycle by all means I have repaired on us and wear it. Please tell the manufacturer side that the inspection is solid. It is regrettable though it is a good product.
Although not attached yet, since the switch width is smaller than genuine, the clutch lever degree of freedom can rise, the hand switch for the rally meter is attached to the empty gap. The same thing is sold at the same price other than the manufacturer, it is a quality Chinese appearance, but it is acceptable price level. Only a narrow switch can be found. Although the turn signal sw is not push cancellation, I think that it is good to see when the switch is touched and to touch the finger to forget to erase the turn signal, forget to put out. When watching forward and watching the indicator, push cancellation has not forgotten to erase unless you see a winker indicator, you do not know forget to put out. I think the wiring is short 10 CM to XR 250 baja (MD 30). Because I do not use Giboshi, I would like you to sell it without monotaro brand without Giboshi.
The small size is very easy to use. The seesaw type turn signal switch is surprisingly easy to use. But it is common in this series, but the display of the horn button and cell switch button is a seal. Although there is no problem with the seal, it is always pasted slightly off the concave part at the seal position, and the end of the seal is floating slightly. I carefully peeled each time and paste it again, but I want you to improve the work quality of sticking the seal.