The reviews are automatic translation.
Development of bicycle
On 2015-10-02 16:33:06
I tried to use the 11-speed transmission Shimano RD-5800.
The difference in speed performance compared with Shimano genuine products is not seen.
Thin Teflon coating compared to the genuine, for the
And the wire diameter feel thinner mood, if not careful when wiring
It will be immediately return a twist in each time hands on loosened.
Fixing of the cable would be better not done many times.
Although there are some constraints to handle because of the cost down,
Knowledge and I think if useful product use.
On 2014-10-13 12:20:00
Pull Tsu light.
Cross bikes and MTB of maintenance
On 2013-12-28 19:58:13
Is a report of the exchange to more than one year has elapsed situation.
The effect of the coating, rust does not occur,
Pull of the shift lever is also followed by a mild state.
On 2013-10-25 11:12:35
I ordered because it is two meters in length, but did not know well in the photo, certainly only cable, was really is wanted with a tube (exterior).
I wore a bicycle
On 2013-02-24 10:25:59
You can use normally.
Since the PTFE-coated stainless steel
I bought I think longevity.
I think that may in the not sold in home improvement
Cross bike maintenance
On 2012-10-28 22:28:15
Bicycle outdoor storage, we sometimes ended up being caught in the rain.
It was exchanged in the fray from the rust of this order or originally wire that was used.
In three months use, initial growth is also not float without any rust, not Yes peeling of the P.T.F.E coat.
Lightness of the pull of the wire by P.T.F.E. coat, but I was not able to experience,
Rust effect was felt to be superior.
Ideal for full outer
On 2012-10-06 18:42:23
It was in full outer frame, the outer and the inner resistance increases, has been plagued by gear shift defect. Even in normal outer such as alligator, you can now shift normally and use it to inner.
1. wire of this kind should not be with a conventional grease during assembly. Will reverse effect becomes poor slip with a solid (grease sealed already outer also be bad)
2. Note the screw tightening so slippery in the mounting portion of the derailleur.
On 2012-03-27 18:36:43
The PTFE coating, slip is good. But, hard as compared with the third-party wire, derailleur is no problem when you go to pull the wire to shift from the normal state, when the slide into release the wire, the wire is loosened and the housing of the flexural modulus of the shift cable is tight it feels like Going in the direction. This may not successfully shift.