The reviews are automatic translation.
Bike chain cut
On 2017-03-22 18:34:14
I think the price basis that it is normal.
Whether the pin is poor place is what you like for the cut.
Used in Selo 250
On 2017-01-04 18:21:24
428 chain of Theroux 250 was used to cut. It goes without any problems with the use of from cutting the caulking part in the grinder.
The do not cut the caulking part is truly impossible Poi feel.
It is a commodity of very happy
Turnip for the chain replacement!
On 2016-11-03 18:59:38
We decided to see net review!
COSPA good ♪
On 2016-10-11 18:59:05
520 was used for the exchange of the size, but there were doubts about the strength, but it was used without problem. I was using the cheap ones of Made in China, but I bought hurriedly add this item because the pin of extrusion was crushed. It was good to buy. It works hard to shift compared to a single type I is was easy.
At the time of maintenance of the bike
On 2016-05-18 15:50:49
It was the first time the chain exchange, I was able to easily remove.
On 2015-07-25 19:38:50
520 was used to seal chain.
A review reference, I used to turn OFF the caulking portion in Ryuta.
It could be used without problems.
520 used in the chain cutter
On 2014-09-01 13:16:53
Advance since the use by cutting the pin in the Thunder did not have a problem.
Was replaced there was no particular problem because not a caulking type of chain.
You can well and occupy the pre-pin from against the hole.
On 2014-07-17 13:45:56
I do not buy again, but we used a chain cut of useless would lack the tip of the rod to push the pin 520
Removal of the motorcycle chain
On 2013-07-31 21:31:12
Not cut the caulking part in the grinder is regrettable that had to.
428 chain cut
On 2012-09-15 00:14:24
520 hole position of is no problem, but the position of the 428 is only the thickness of 1mm from the end of the commodity. Although pin of the head was used to skip a little grinder, but still too hard pin positions are shifted from the core. Then immediately cause distortion because the thickness is not, useless. Without a wall thickness of more than 5mm, the strength in the aluminum of the body does not have a matter of course. Since the new goods were carefully cut, but there is nothing so difficult to use until now. It has broken and deformed in just one use. The tool I realized that there is no one person that actually the manufacturing was designed.