The reviews are automatic translation.
We exchanged with deterioration.
On 2017-06-06 18:33:39
I could not cling to the wire and it was a bit painful. I removed the resin part and confirmed the structure, so I brought it. (It was not as easy as the manual)
On 2017-05-12 16:57:36
I am saved because we also supply such small parts.
For Bridgestone Wagon
On 2017-04-30 04:46:44
I purchased it for exchange for the Bridgestone Wagon. It is the same as genuine. The resin near the metal band for attaching the handle is easy to break. When spreading the metal band, the resin may break. Tyco of shift wire is difficult to install. Also the instructions are difficult to understand. Please stop when installing
On 2017-04-23 22:48:01
Existing cover has broken and body is also old so it is an exchange. It is almost impossible to attach the wire unless you remove the cover, but it is difficult to remove the cover. It is likely to crack. We only sell the cover part, so let's buy only the cover after cracking.
On 2017-04-03 23:30:15
The wire sticks out, broke it during repair, I bought it with the wire. The instructions are hard to understand, but there was not any problem in removing the cover. I can not distinguish between real and fresh. enough.
Modification of bicycle (addition of transmission)
On 2017-03-03 21:38:55
1-2 was slightly astringent, and it was necessary to lubricate. Was grease a little stiff? The next operation could not be done unless the shift up lever was returned by hand. If you poured 5-56 you can use it well.
Replacement of obsolete parts
On 2017-02-22 20:05:53
After all I had a hard time setting tyco of shift wire. I removed the screws of the main unit and set the tyco after removing the plastic cover. When removing the plastic cover, removing the gray part of the tip makes it easy for the cover to come off. It is impossible to set a wire only by watching the manual as if it were first look.
On 2017-01-13 13:47:20
I bought it for bicycle reform for school bicycle. It was a little difficult to install, such as the wire being disengaged or it seems to crack when plastic cover is inserted. After completion of installation, it became possible to shift quickly and comfortably, I was satisfied very much.
On 2017-01-11 18:22:36
It is very helpful to get the same parts as genuine at a cheaper price than a home center normally. I was pleased very much with the resurgence of a stylish feel.
Mama-chan transmission repair
On 2016-11-16 15:14:06
Although other people have written, Shimano's installation instructions are unfriendly. As a trick, first loosen the cable adjuster bolt in "How to adjust the bell crank" on the right side of the instruction manual and lengthen the wire as much as possible. 2 Remove the screw under the cover of the transmission. Otherwise you can not see the hole to tie the wire tie. When installing the three speed change cable, fix the wire without fixing the transmission to the steering wheel. (In this case, making the lever the 1st speed makes it easy to put in the gap.) Then change the speed to the 2nd speed (lower right), the gap will be gone and it will be difficult for the wire to disengage.When the tyco of the wire It is important to confirm that it is properly attached.) 4 Install the transmission. 5 Adjust the bell crank. I would like anyone to see the instruction manual so that I can understand it.