The reviews are automatic translation.
Drilling of a frame of a large-sized vehicle and body processing
On 2018-04-11 19:06:11
I tried to drill a 20 mm iron plate with 12 mm drill. I used a grinding oil spray, but I got a hole beautifully comfortably without having heat. Is it possible with high tension?
For plastic processing
On 2018-01-07 16:56:09
With the drill blade up to now I was in trouble because the cutting edge was quite rampant, but this product can not drill a blade and can drill a very beautiful perfect circular hole.
t0.5 Drilling of tinplate
On 2017-09-08 13:38:40
Used in drilling machine.
Although the position is easy to target, Bali will appear as it is and no real circle will come out.
Eventually, deburring also became necessary through reamers.
Drilling to 5 mm thick resin plate
On 2017-02-02 15:05:36
In ordinary drills for iron and steel, when the bit penetrates, it gets caught on the board and the hole can not be opened beautifully, but you can drill precisely without using this bit or casually though the hole can not be opened cleanly. However, since it will be caught if you send it earlier so as to open a hole early, I think that it is a point to send slowly.
Drilling of plastics
On 2016-03-01 22:17:29
It was good because drilling at one time is possible
To use for drilling on thin plate
On 2015-11-08 18:54:06
The hole can be machined to the thin plate as accurately as possible.
I attach a small cut ball to the flat bottom hole, but this drill may be good
On 2015-08-18 17:09:03
It was good that the holes opened and the cut beads were firmly glued as expected.
Drilling of plastic
On 2014-10-18 00:16:41
I bought it for drilling of plastic. Although the back burr is also so, the table burr drastically decreases and it is saved very much. The place which can be used also for ironworks is very convenient.
Used for handrail processing
On 2013-11-16 08:18:05
Although it is used for drilling aluminum, it is okay that burrs are not necessarily, but aluminum dregs often can not be removed. Considering the trouble of taking Bali, I think that it is faster to take off the dust.
Drilling of aluminum plate and iron plate.
On 2013-07-25 20:36:58
Aluminum plate 1.5 t, iron plate 1.0 t with general drill and comparing this product under the same condition Almost no superiority or inferiority.