It is better to sell one. Since it usually sells 10 sheets, it is enough for a small amount when used for hobbies such as DIY. Also, I am afraid that it is a unit of ten sheets of belts that I do not know whether it is good or not, and I can not get a hand at a high price. I would also like other belts to consider selling one sheet by all means.
# 60 is used but since stainless steel is hard it does not count its eyes as it gets numbered (it is finer than the # 180 of the HL material of the manufacturer's polished) so that a harder abrasive can be used even with stainless steel using a harder abrasive want
Copper, copper alloy hairline and scratches and oxide film dropping.
On 2015-06-20 00:33:10
I bought this product of 600 number which 3M goods only had up to 400 and the price was a bit cheap, but it is easy to pierce anyhow! Especially at both ends, it is noticeable, but if you hit a workpiece (especially if you hit the edge of the workpiece) it will be peeled. Is it the only advantage that it is easy for familiarity to work with thickness and curved surface? I want to raise durability.