The reviews are automatic translation.
As a vise of the drilling machine
On 2015-10-26 23:51:18
I think that play is somewhat large in a place I can not treat, but I think that the cost effectiveness is great. It is enough for me of DIY youth.
Simplified milling with a drilling machine
On 2015-05-22 07:15:20
Although it is used in the range of hobbies, planar processing of materials indispensable indispensable, right angle processing of the edge. Until now, I fixed it by hand, and I am dissatisfied and injured in finishing. Even if it corresponds to the price precisely, it became much easier. Pleasure you can cut without touching the processed material? I am tasting. As a matter of course as a machine, considerable adjustment is necessary to operate once. Also, because of oil for rust prevention, it was semi-decomposed and washed with magicryn and greased again. I think whether the working space can be earned if the total height is a bit lower than the improvement desired point.
It is used for holding the vice of a wood processing lathe at cutting.
On 2015-03-17 16:02:15
Current woodworking lathes use processed vice (cutlery) manually to cut materials and process the workpieces (wood), but depending on things centering is necessary, so we will use cross vice purchased this time By doing so, centering became very easy. Given the purpose of future use, I think whether ease of use will improve if there are goods that can move the slide part (length and breadth) a little more.
Drilling work and width processing
On 2014-06-02 15:02:38
Pitch drilling work on the same line is very difficult, it can process with higher accuracy. 0.1mm work is possible for trimmer processing of groove machining. (With dial gauge) Cross vice is accidentally touched in this catalog and ordered it immediately. I am enjoying using the CAD software with hexagon, octagon, dodecagon as well as squares at the picture frame as well as good work.
Milling operation with desktop drill
On 2013-05-10 22:35:29
Although there are adjustment screws for the yoke, the accuracy may not be for the lathe again. I never said that if the clamp part rotated 90 degrees.