Spoke CP

At first I was organizing at 14G, but I decided to replace it with 12G one after another, but I did not seem to handle it at Mono. It is a follow-up observation for durability for a while. It is saved if you can handle 12G as a rear wheel.

The appearance is better for stainless steel but sticky for iron looks better, less likely to break and easy to roll the thread. It would be even better if you divide it, but in any case, it is appreciated that it can be obtained even by end users.

I used spokes for repairing a broken bicycle. I thought that the number was large, but eventually I exchanged all the spokes. It got cheap. It was also easier than I expected. The fretting of the wheel was a big deal.

There was a fine length setting so I was able to buy a thing that is perfect.

I am saved for the old bicycle restore. It is surprisingly easy to exchange.

I am satisfied that the spokes broke in turn and I could not get it at the home center and I could cheaply change the place I was looking for

27 inch general car rear wheel wheel for recombination purchase did. Since it is often broken off from the screw thread part when it is No. 13 spoke, I rearranged the screw thread with No. 14 threaded thread. In addition, the nipple was rusted and made brass so that it could not be removed. There are only 36, so it is half as much as possible, but I think that the remainder will be cut to arbitrary length with spoke cutter and used for repair.

I spun several spokes of the rear wheel of Mamari Chari, so I used it for repair. Quality is satisfactory. I'd appreciate it if you have 5 or 10 sets.

I am looking for how durable it is

I bought 72 bottles for several exchanges. I want you to sell it in units of 10 pieces.