Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
5 Customer Reviews
The reviews are automatic translation.
On 2017-01-16 11:52:46
Of manufacturing accuracy is good. Due to the use to the axis of rotation, in the application, it is a little more tight is desirable.
Used to connect the drive shaft with 3mm of the motor shaft
On 2015-11-24 17:33:47
Is a hole to put the motor shaft of 3mm was a little Shibuka', but entered somehow.
Person of 6mm originally diameter because it was Zungiriboruto has entered no small problem.
Although the inner diameter of the specification column is welcome and get to put a dimensional tolerance.
Towards the 6mm hole of is each other off to tap the two places for the set screw, I thought to have been friendly to the small place.
Although not used yet in fact, it is a good feeling of operation check.
Connection of the motor and driver
On 2015-05-29 16:23:23
Accuracy even when there is a good chance I think that if you try to buy again
Of the stepping motor bearing
On 2015-03-25 13:59:30
Of the stepping motor shaft in φ5mm, the subject of the shaft to be driven was in trouble in connection with φ3mm.
It's there is such a component. And attached to the set screw of the shaft fixed.
The us of the request meets 100%. it is perfect.
To convert the variable resistor of inch size axis in common shaft diameter
On 2015-02-13 00:44:41
Because just when fitting the sleeve to the inch size shaft becomes 8mm, you can use this different diameter joint.
But now need a lot of depth, variable resistor knob dial of the general for the special
can not use. Since the dial for the inch-axis will be custom-made, it can be convinced to think the whole of the cost
It was range.
Customers Who Bought This Item Also Bought
FYH (Nippon Pillow Block)
Kohara Gear Industry (KHK)