The reviews are automatic translation.
Iron Frame Cross Bikes
On 2016-04-05 23:32:15
It is more stable than the back stand. It bends slightly. It is the most disadvantage that it is impossible to adjust the speed by setting up the stand. With the bicycle of the aluminum frame, the gap was narrow, and the bending of the upper iron plate was disturbing and it could not be attached. It is possible if it is also a flat plate.
On 2015-06-03 08:51:23
It is affordable, quality seems to be no problem. I do not need a red sticker with strange design. Because it is made of aluminum, the strength etc. when using for a long time are still unknown now.
Sympathy from side stand
On 2015-01-25 03:24:38
The texture is above the price, the feeling that snaps into a click when the stand is lowered is very good, and if you adjust the length correctly you will have a sense of stability. Because the installation was a single screw and the mounting part was not so thin it was -1 because the stand may rotate with a slight impact.
On 2014-07-15 09:25:04
Compared with the type attached near the rear wheel, the fit during traveling is good, showing a very stable function. It is comfortable without hitting shoes while driving. It is much easier to install than the rear wheel type.
MTB center stand
On 2014-06-22 10:24:41
I did not know that I wore a center stand for the first time but I can not do back. Although it can be solved if it is L-shaped, no manufacturer is made. I chose the cheapest, but the aluminum is too weak to fuja nya. It is weaker than Mamari Chari's side stand. Iron material is enough because it is a stick. If it is made of aluminum, it should be a hard aluminum alloy containing a lot of duralumin, but because the price is price, there is no place to go there. I attached it to the 26-inch MTB, but it does not stabilize because it is too tilted even if it is the longest. I bought an 8 mm aluminum plate without any help. Should have a shape that would extend longer.
For bicycle assembly
On 2014-06-11 22:05:57
I removed this cross bike's side stand and installed this center stand instead. The appearance of the bicycle becomes refreshing better. It is made of total metal and has plenty of luxury. It is important to fix firmly so that it does not slip and to interfere when turning the crank when using the stand.
Bicycle center stand
On 2014-05-10 19:20:17
I attached a 700 x 32 C tire to a cross bike that is being worn. There is no interference with gears, cranks and tires. In addition, adjustment of the length was not necessary either. In the photograph, the part of the hinge was seen as plastic, so I was worried about aged deterioration, but the real thing is firmly made with metal (it is heavy correspondingly). Since the point which I was concerned with is not attached with a slip stopper such as rubber at the contact part with the frame, as it is worn as it is, it will be misled while using it as other people wrote.
Mounting on MTB without stand
On 2012-07-11 22:17:17
I installed it to 26 inch MTB, but it was perfect as it was. I use the center stand for the first time, but I feel better balance when parking than rear stand. However, because the installation is only 1 bolt, if you are doing the stand operation many times, slight misalignment will occur due to the momentum of the spring. Moreover, since the bolt feels like steel, I am worried about whether it will rust (follow-up observation is necessary) Even if the above is taken into consideration, I think that cost performance is outstanding as this price. It is a recommended item.