The reviews are automatic translation.
Processed product production
On 2017-04-14 15:39:03
It is used for original production such as cutting and cutting.
On 2017-04-07 11:50:39
Since the distance from the edge of the breaker to the breaker groove is too far, the facet does not round and straight out and it is dangerous and can not be used.
Cutting of sleeve
On 2016-06-28 18:23:07
I cut the thick sleeve of S45C, but it was able to perform stable processing.
On 2016-03-08 21:48:14
On 2014-05-22 22:01:23
For now it is using it without problems. Sharpness is also good and I have not used much yet, but I think that it seems to have durability.
On 2012-07-19 00:33:14
Cost · Usability is OK. Currently it is installed and used in a holder made in China.
I use it by cutting it. This time for the first time I used the MonotaRO chip.
On 2012-03-14 21:44:44
Although it is an impression that I used cutting chip, I use only aluminum 17S and iron 1215, but there is no problem, I have never replaced chips. We do not use stain 304 etc, so we do not understand yet. Since it is attached to the holder of Iskkar, the price is cheap and it is saved. Improvement point etc. I do not understand yet, but I think that I would like to impress again when using it such as Sten 304 in the future.
On 2012-03-12 23:08:41
I could not cut it and cut it.
Cutting off the NC lathe.
On 2012-03-02 15:38:13
It can also be used for SUS304 * SUS316, it is a very reasonable break-through chip.
Cutting of iron, stainless steel, hard aluminum.
On 2012-01-20 12:32:39
The workpiece is P type (steel), but with light cutting, there is no particular problem with either stainless steel or aluminum. Compared to Ishikaru genuine, it is not visible and it is not bad, but I will consider whether to continue also next time. (I think that it will take several years depending on how often I use it.) If possible, I would like blades to be added to the lineup.