The reviews are automatic translation.
Cutting of steel material and pipe receiving of pipe machine
On 2018-06-16 16:25:18
Because the width of the roller is wide, the degree of freedom of the material works and the roller slipping is good, so it was satisfying.
When cutting with a high-speed cutter
On 2017-10-25 15:09:45
I think that it would be straightforward if a fall stop was attached to the end.
When pipe cut
On 2017-09-20 16:48:54
It was a good product due to price. Thank you very much.
Electric piping construction, pipe processing
On 2017-06-05 20:49:39
It is handy because it is light and stable, if there are projections for anti-slip at both ends of the roller.
Supports cutting material with band saw
On 2016-10-08 20:57:01
It was firmly in proportion to the amount and it was very convenient to use.
Used for height adjustment when cutting wood
On 2016-07-07 16:35:19
When cutting a long board with a slide circular saw, I was struggling to adjust the height, but the height was adjusted precisely and the working efficiency improved. I should have bought it soon.
Used in slide circular saws and high speed cutters
On 2014-01-30 13:24:01
Speaking of cost performance, I am satisfied. Although I can not say luxury in this price range, it is surprisingly difficult to turn up and down adjustment knobs, so dissatisfaction will disappear if the feed relative to turning amount is a little bigger. Also, WRS - 4 has become less concerned laterally misaligned by changing the angle I was concerned with WRS - 3. There is nothing else in this roller width at this price, so is not it good?
Height adjustment and feeding at the time of cutting long material
On 2013-03-07 00:22:39
The accuracy of the roller part is sweet. When it rotates, it shakes 1 to 2 mm up and down at the center. Although it may be just a losing due to individual differences just arrived. As far as use is concerned, precision does not matter so much, so it can be used normally. When adjusting the height, once you lower it to the target height when you raise it again after raising it again, if you hold it down from above with a hand it will fall about 5 mm, so turn the knob a half turn further to the right and do not raise it by the amount you lowered It does not seem to be.