I installed and lubricated on the wire whose movement went bad. I left it for about 1 week, removed and checked the movement. It is good. I also soaked in kerosene before lubrication. As a result of injecting spray grease after injecting the lubricant, the movement became the same as the new one.
I was able to inject lubricating oil and grease very well to the thick wire of agricultural machinery (management machine and cultivator). The worry before buying was useless. Thin wire like a throttle wire was injected after wrapping the paking tape used for waterwork construction, but it was able to do it well. Thanks to you, the function of the machine revives and you can do farm work with a pleasant feeling. There is no problem in practical use, but it is easier to come out if the rubber sandwiching the outwire is used several times.
I had a single type, but CRC also had a lot of liquid leaks, so grease could not be injected so buy a double type with no good. Single needs to inject little by little over time to feel like shuushu, it is quite persistent and there are many leaks, but the double has much higher adhesion than I thought, almost without leaking at once I could inject it. Thanks to liquid grease smoothly completed injection. One problem is that it can not be installed without a wire stroke because the main body becomes longer than a single. My motorcycle entered the rear brake wire but the front did not enter. Incidentally, as a way to use it is done by first draining dirt (mainly rust) in the wire with CRC etc. until it exits and filling with liquid wire grease until it exits from the end. Movement will improve as if it became a new item. I think that old motorcycle, those who ride a car are essential items.