The reviews are automatic translation.
Replacement of controller SW
On 2017-05-17 15:10:25
Although it is satisfactory in terms of functioning, I think that lever is a bit. A slightly lighter one is easier to use.
Installation on car
On 2017-04-30 18:32:13
It is used to switch between car's internal power supply and external power supply. Since the allowable current is 30 A, it can be used with confidence. Since the wiring is screwed, it can be done comfortably. It is good that the operation of the lever is a little lighter.
Because there is a loss of 0.6V ~ 1V the charge-discharge circuit that it is running charge to the camper of the sub-battery, it has been improved so that it can be directly connected in the loss eliminated for manual.
On 2017-03-05 08:04:23
Since the flow is always 10A of the before and after the current from the state of the circuit (I wanted to support up to a maximum of 30A position), it has been looking for an adequate response can be part, I think that it was good to find the products that will meet the hope.
It used to switch in order to monitor the two amplifier output in one set of speakers
On 2017-01-28 23:09:42
It had been able to robust than I thought. But I did not know the product photography, connection electrode is easy to use with a screw.
Operation of the forward and reverse rotation of the motor
On 2016-08-10 16:20:12
Are we satisfied with the stable performance.
solar power and general power supply switching
On 2016-06-13 19:35:09
solar power to charge the battery in, and 100V in the inverter, because it uses a lot on the first floor ceiling lighting,
Cloudy day, not enough power.
So, back on switching to the local power.
You can take advantage of condition good.
1-point problem, because the spring is tricky switching in the strong woman. Decompose, the spring was a little short, I use lightly about 20 percent.
So do not if it fails, you have two co-purchase. Both co-Tsukaemasu successfully.
Automotive electrical system of the switch
On 2015-06-10 19:09:34
The price in this capacity, we are very satisfied.
Forward reverse change-over switch of the three-phase motor
On 2014-10-29 17:34:06
It was used as a forward reverse change-over switch of the three-phase motor in the user's request.
Since there is a sufficient margin to the load capacity, I think that it can be used longer.