The reviews are automatic translation.
In tap cutting of electric mount etc
On 2017-04-12 23:59:08
Convenient because it allows you to drill holes with a single shot in addition to the impact! There is no need to change the drill bit to tap every time! It is not necessary to prepare separately for drill blade and tap! I think that time can be shortened, preparations of accessories can be reduced.
Screw hole drilling at the time of equipment attached
On 2016-08-24 10:40:28
Became unusable mountain collapsed just by using a few times
This does not bring myself to buy in the future I just use an ordinary iron plate
On 2016-03-15 15:04:45
When the break because there is a little high price
Shock is large!
Used to lock the mounting work
On 2016-03-06 15:44:07
I think that is good and a little more strong tip.
Tap opening of control panel
On 2015-07-16 15:16:20
It is useful at the work site and it is tremendously useful. Since I started using it, I used all of this small tap and thin tap. In the case of materials requiring precision or thick materials, it is sufficient to perform drilling and tapping separately as usual. I think that it is a very good product unless impossible. It is advancing to everyone.
On 2015-05-12 17:53:03
Although ordered with stainless steel usable, when the actual arrives and seeing the package, it is "stainless steel heat treated steel material unusable". Nagasaki Savoy System
Work in board, parts installation
On 2015-02-11 01:19:16
Drilling and tapping can be done at the same time, work is done quickly, but durability is not good, after opening a small pilot hole, the position using the tap drill is accurately determined and the problem of durability is still cleared , You can work faster than using drills and taps
On 2014-09-06 09:57:15
Easy to use
Steel material tapped
On 2014-02-16 19:11:33
Since there is no pilot hole, speed up work
Tap cutting at the same time as drilling
On 2013-10-23 09:09:20
That's excellent. If you say difficulty, you should reduce the skidding of drilling.