The reviews are automatic translation.
It repaired that the place where the tap was directly stood became an idiot on the aluminum die cast part made of hobby antenna.
From Japan
On 2017-12-25 16:54:23
Even with lubricating oil, it was difficult to cut the thread vertically in the work of tapping. Was it impossible to manually tap 8 mm?
To correct screw thread of oil pan
From Japan
On 2017-12-09 07:37:54
It was used for screw thread correction of drain cock of aluminum oil pan.
Screw thread playback
From Japan
On 2017-10-30 18:29:11
Recoil is very good, no matter which size you use.
Correction of thread of resin tank
From Japan
On 2017-06-08 10:31:29
Naturally but usability is generally good, every time though it is a dreadfully expensive price is a difficult point, if you arrange separately with a single item, there is no doubt that this amount is something you can manage ...
Car Maintenance
From Japan
On 2017-05-06 14:08:11
I'm satisfied because I received it immediately after ordering I would like to ask again
Motorcycle repair
From Japan
On 2017-02-04 11:40:23
The work ended smoothly in a short time, and it was also good to use!
Motorcycle repair
From Japan
On 2017-02-03 17:49:53
The work ended smoothly in a short time, and it was also good to use!
Bike muffler flange stud bolt with rust rust
From Japan
On 2016-06-12 20:59:16
All necessary items such as drill and tongue folding rod with magnet were attached and it was convenient.
Repair
From Japan
On 2016-06-07 14:54:23
It is slightly higher than cheap recoil, but it is definitely here by usability and performance. I am satisfied well of the attached drill.
Used for screw thread correction of aluminum material such as engine
From Japan
On 2016-05-07 22:33:09
It is okay if you get used to it, but please be careful as there are a few tips when putting in the coil. I hope to have a comprehensive explanation