The automatic feed timer of the low frequency furnace was broken, so I replaced it.
On 2017-05-22 19:48:15
Since it was listed on the manufacturer's website as a recommended substitute for NSY which had been finished production in March 1998, I bought it. Although the mounting dimensions were fully compatible, wiring attention requires some care. I can use it without any problem.
It is very good to be able to set up seconds, minutes, hours, but it is good if the setting place is on the lower side of the side It is good if there is plenty of fault mounting space, but there is no room for the existing space In order to change the seconds, minutes, hours you have to remove the timer body. (Other timers will be switched on the face of the dial.) It will be great if you can switch freely at the completion of installation.
It has good visibility and operability, and there are only waterproof analog timers. Caution on connection: Normal handling of timer is in operation. Care must be taken for many timers because they are normal during non-operation. In order to use it as a general timer, it is necessary to take AND with NC and timer power supply.