The reviews are automatic translation.
Materials for jigs
On 2017-05-23 16:33:24
Easy to process, cheap and other materials can not be used It is the best because insulation is also necessary
Manufacture of hose plug
On 2017-04-05 16:34:26
Those short of about 300mm is also to choose and easy to purchase.
It survives very easy processing
On 2017-02-21 00:23:26
Imamade jelly, but it was, Gong and try to ts have thank you from this tr
Production of the air cylinder
On 2016-11-21 18:03:10
Dimensions minus is not, it was what was decent. It is a big satisfaction.
On 2016-05-23 15:18:14
Cutting ability is good. There is no complaint point.
On 2016-04-12 18:04:03
For wear of the existing plastic bearing is terrible, we tried to make the alternative. Goods here of POM. Strength, is a wear resistance good.
On 2016-03-09 20:25:00
For the shaft of the drive shaft
On 2016-02-26 20:03:14
Part load is applied uses the SUS, Engineering A ring plastic of the tensile strength (MPa [kgf / cm2]) 61  is
We have enough strength to, and it will be saved cutting that effortless.
Since the mating of clearance is also unlike the metal it will also be the noise measures, from SUS
I think that may be changed here.
... In part the creation of electrical and model tools parts
On 2015-12-06 21:59:46
To Φ27.5mm also there is a thick, bent about 5 ~ 10mm at 1000mm.
It seems that there is a considerable problem in the storage and preservation methods.
(And leaning against and are stored and saved, you bend under gravity. If such products are required to store and save lay always, and turn all regardless of the thickness.)
If you're bent from immediately after production, I want you to take bigger tolerance. (+ 15mm or more)
So that there is no bend in the lathe, After shaving so as to be less tolerance 0.1mm, 5 ~ 10mm than purchase size is thin.
Poly pen co-acetal (POM) round bar seems to be better to white was also thought to have bent new goods also regardless of the black even thickness.
Further, the surface is dirty white. Wipe with something of chemicals, with a dry cloth to feel like not, liquid was dripping mark is in the whole.
On 2015-12-04 20:16:23
Since the spacer hinge has been worn have built round bar processing, but seems to be a lack of strength