Thorough drilling of thin slabs (thin plates)
On 2013-12-04 00:35:37
I have forgotten the manufacturer of this hand long ago, but there is something made of foundry, why the center is raised for some reason, when drilling a thin plate, drilling the pushcop at the very end of the hole diameter Since it spreads by itself (for avoiding bibi), since the bite and the raised part collide with each other, we had to scratch the protrusion of the holder every time, but this product is straight so it is good. However, a bit of lineup is too small (Some sweat old type has more than 3 minutes, 4 minutes, 5 minute bytes included, too small.After you put it normally you will get a bit of it, If you put it in contrary, there is a case where it does not enter it very much (at that time, I cut a bit of a byte with a grinder) I also wanted to make 1 mm wide wider.Also it is effective for this product, thin material shaving, but innocent It is too delicate to cut things (I use a 6-scale lathe) Vibrating (vibration) occurs and it does not become usable (So, I think that the old type became out of print) Buy this Which people do you use? In lathe work, people who scrape light things are a few from the whole, are not they? I do not know because I have not used it, but I wonder if they are mini lathes (So there are only a small lineup?) I'm worried It is a nice item for people who do thin cutting.The holders of ordinary lathes are so delicate that the hands of iron like innocent sheepskin I buy the material, cut it with a milling cutter (as a specially designed holder) and I will do my job.