The reviews are automatic translation.
Iron: 1.6mm about drilling
On 2017-02-27 10:19:40
There is a problem can not order only drill parts of consumable parts.
Air conditioning construction
On 2016-08-16 11:31:05
This type of shank has been purchased for the first time.
Exchange of Holsoe also allow only easy to slide
I think that good. But there are other of those reviews
... Embedded in the hexagonal screws may be careful so as not to come off in the vibration
docomo antenna construction
On 2016-07-27 16:32:48
The center drill and other parts I want you to sell separately.
Since the blade of the center drill is lost will fall into the wall when using this product first to be best to say, I want a spare blade
Piping wall opening
On 2016-05-28 07:10:55
Spring potato screws that hold the movable portion is disengaged by the vibration at the time of the work, the ball flew. I use and repaired with plastic tape. It struggles to when removing the core and do not have this part. This is where I want ideas that potato screw does not come off.
Drilling of woodworking work
On 2015-11-08 18:11:14
Although a little structure made of USA, which already have different, versatility is satisfactory.
In Product Description I want you to describe in detail the size such as the distance between the Rock Hall.
Overlapped with that we already have.
Steel pipe, drilling to the SUS tube
On 2015-01-13 00:07:44
Because set screw to stop the center drill is negative screw, it takes a lot of trouble if the exchange is needed in breakage, etc. of the drill.
Although the screw itself decided to use to replace the ones of the M8 so hex, the domestic manufacturers started another company because this part is a first hex, I felt the difference in the mindset (culture) with Europe.
Sharpness of the blade is not bad, also inexpensive because the utilization and increase the size of the blade little by little in our company is located in the expansion trend.
68 drill holes of mounting a Holsoe
On 2014-09-16 21:16:55
Were you are replacing the Kiri center tries Yurumeyo the screw with a flathead screwdriver, completely loose there is no state, so that they will not become loose broken minus be loosened in impact driver, which was considered the exchange was open them as useless is written on, it has been bought a lot of goods until now, from now on I thought I have to buy think utensils.
Screw such goods not loosen is poor. (Kiri of the center can not be replaced)
Such as the installation of drilling Denki board
On 2014-02-02 19:10:30
Bas - the core - is a matter of the bus, but there is a spring in between the place occupied hex you have think you Horuso deviation and is better all closed with the hexagon
Outer wall drilling
On 2013-01-08 12:12:42
Structure plywood and Garba two Umm steel plate was used to either.