The reviews are automatic translation.
Car harness installation repair
On 2017-09-14 22:01:44
It was easy to use. It can be used without trouble even after installation, it is easy and recommended for those who do not need hand nutter.
Repair of a thin iron plate
On 2017-09-07 14:54:58
Although it is good that it is easy to use, it is good if the number of rivets is a little more.
For MINI Cooper's door mirror base hole
On 2017-08-07 12:18:22
It might be the best if there was a stopper on the underside so as not to come out from the wrench.
Added Hiace inner wall screw hole
On 2017-07-07 15:49:56
Nutter, I bought it before and it should be somewhere, but, purchased from the thought that.
Approximately 10 bolts will get caught. I could not talk at all if I replaced it with bolt on hand.
To fix the seat
On 2017-05-18 23:52:02
(Pull formula) and (spin formula). Ordinary aluminum fans are hard and will not turn. A bit nutter is a tool exclusively for "shrimp knurled nut".
Mounting parts on car body
On 2017-04-15 09:05:48
The attachment of the nutter was attached easily and comparatively. There was a part where tightening of some Nutter did not go well.
Mounting of blind nut to body and frame steel plate
On 2017-01-15 00:23:22
Basically it is the same thing as the method of tightening up the blind nut by using the large diameter nut and the bolt in the same way, but it is exclusive to the fluffy stone, and the M17 nut is knurled with anti-slip knurl on the side that hits the blind nut It has been devised that it is attached or that an o - ring is attached so that the spectacle wrench will not fall off. The manual on the back of the backing sheet is also polite and polite and details how many tighten the hexagon nut for each thickness, etc. are written in detail. Work can be done in a narrow place and if it is a premise that only blind nuts up to M4 - M6 are used, it may be easier than processing a riveter to make hand nutter by yourself.
On 2017-01-12 16:32:28
It looks like a handy item, but I think that it became practical enough.
Tighten the blind nut
On 2016-04-22 11:32:34
Sometimes, to install several blind nuts, there is no problem. It is enough for such use.
To make threads on the thin plate.
On 2016-04-21 17:05:36
Even if you do not use hand nutter, you can make it with just a hex wrench and it is very cheap. I used a hexagonal wrench (5 mm) with an impact driver because it was numerous.