The reviews are automatic translation.
As part of the parts inside the carburetor
On 2017-02-24 21:21:32
Since it is a standard item, there is no problem. It will be saved if the standard is a little finer
It is production of antenna.
On 2017-01-31 19:53:10
I tried making the antenna trial so I bought it. Since soldering is necessary, I made it into a brass pipe. It is easy to process.
As a member to be used for repairing machinery etc.
On 2017-01-25 20:22:28
As it is a "member" of brass round pipe, it is not so much as to comment. I am satisfied with what I am doing.
On 2017-01-14 01:14:17
Packaging was also good, and despite delicate goods I arrived without deformation
On 2016-12-27 14:50:42
I stocked the material to use for modeling work, this time I purchased four kinds of brass pipes. Actual use is still. It is probably the same as being sold at model shops etc, but it was good that the price was cheap and the length was long. Although the brass pipe is in the case of the transparent plastic pipe, the item tag is pasted on the cap at the tip of the plastic pipe, and it is necessary to cut out part of the tag at the time of opening. This is a difficult point because it makes it difficult to identify after opening. I think that it is better to paste one centimeter away from the tip.
It accommodates the propeller start lot of the model aircraft.
On 2016-11-18 16:28:00
It is truly convenient to pass a 0.8 mm Piano wire. I'm pretty selling it, so I'm happy to be able to purchase it.
Stop pin of wristwatch band
On 2016-11-07 11:47:32
For repairing fine parts such as wristwatches, such brass fine wires are appreciated
On 2016-07-02 16:18:07
I used it as a part of a toy. I got sent soon and I am satisfied with the quality well.
Tyco of wire
On 2016-06-07 21:18:03
I cut it, soldered it through a wire and made it to Tyco. Because it is about 5 mm used, it is saved if there is a little short size.
Nozzle of gas burner
On 2016-05-29 19:27:22
A 0.2 mm gas torch hole was necessary, but the 0.2 mm drill is frightening and delicate and difficult to process. Since the outside diameter of this 0.2 mm hole diameter is 0.6 mm, it will be completed by drilling a 0.6 mmφ hole in the shaft which becomes the sheath and inserting this pipe. I am grateful.