The reviews are automatic translation.
On 2017-08-18 00:09:15
To prevent scratches during construction, double-sided tape is attached to the edge of the equipment.
There is a hand called a safety cushion, but its original purpose is safe so it is expensive and it becomes bulky.
If this is about 1 mm thick it can be reused without bulky, it will protect the edge firmly.
To self-made tools and parts of works
On 2017-05-06 11:33:56
I arrived with the feeling that I found a good one, and I have inflated my expectations in various ways. Although I was worried at the beginning as to whether it was usable or not, it was not so expensive so I tried to purchase it. There is a sense of stability as expected. (However, although there is some feeling of fluffy peculiar to pet material, I like it pretty much). The first thing I used was cut and pasted into an acrylic ruler with a cutter guide and attached a fingertip guard. Until then, since it was a type without a fingertip guard, it was scary when the cutting edge ridden in the ruler excessively. It became convenient. It gives you the feeling of security as expected and you can actually use it as it is. (However, because it will be scraped if the cutting edge hits frequently, a little clearance will be made in relation to the flow line of the blade.) With this, "As One Triangular Adhesion Reinforcing Bar" https://www.monotaro.com/g/00250769/ When combined, the strength and stability further increases, and the sense of security is also improved. After that, I used it several times as a part of my work. If it is affixed as a reinforcement of a folded part such as a PP board, angle, strength and stability will be improved. This is also used in combination with "As One Triangle Adhesion Reinforcing Bar" depending on the situation. It is user-friendly to cut with a cutter. (Although there are a few tips to cut cleanly, there is a way to scrape burrs at cutting with a blade back, but polishing with # 800 to # 1000 polishing paper will improve the touch. In some cases it is better to round the quadrangle)
Joint part between the face and the face of acrylic case of architectural model
On 2016-05-17 23:34:38
It is specified as a member of the mark. Actually, 10 mm is too wide, so we cut it to 5 mm with a special cutter. It is saved if there is 5 mm width · · ·
Wall corner reinforcement
On 2015-08-25 14:44:22
Strength is lower than previous purchase
As a product guide
On 2014-12-15 13:14:37
We changed product guide from aluminum angle to this product. Because it is transparent, products are not hidden when products line up, making appearance inspection easier.