I felt that there was only one improvement. Width was different between when the key cylinder was vertical and when it was lying down, but I thought that it would be better to change the width more widely. If it is the current size, for example, if the hole of the movable flat bar is scraped with a ruther or the like, it seems that it is possible to drill the key cylinder to dive without much effort.
Forbidden locking during periods when there are no subjects in the school outdoor disabled toilet
On 2016-02-08 11:23:22
Although it was puzzled without key coming off at the time of unlocking, it was for injecting lubricating oil spray that it could be removed as a result of the inquiry and it became for removing it. Insufficient key deburring?
Lost the key of the small house used for 30 years. It is in Monotaro's catalog and it was very helpful. Although the mounting bolt of the key before replacement was rusty, it was ridiculous to detach, but it was safe to install and it became usable with confidence. Thank you. The dimensions were perfect.
I bought it as a lock to be attached to a motorcycle's box, I rotate it to lock it, but touch is bad for everyone. There is no complaint because the key is properly applied, but the lot of rattling when turning, the touch when inserting the key is not good. However, the frequency of use is not high and since the function as a lock is played sufficiently in the first place it was enough to think about cost effectiveness. The material is also hard to rust with stainless steel.