The reviews are automatic translation.
When practicing the exam
On 2017-09-20 15:46:27
I was wondering why he was poking two, but I tried using it, I understood. Even with switches or outlets, if you point at plus or minus at the same time and you pull it out, the line will not bend unnecessarily and you can remove it cleanly, with a flat head screwdriver it is quite difficult to use it
Electrical construction professional practical examination measures measures
On 2017-08-30 09:47:38
I searched with a large-sized home center nearby and did not handle it at several stores, I purchased it from here.
Works that had been done with a flathead screwdriver were also made easier by using a special key
I was able to do it surely. (In the case of a flat-blade screwdriver, the equipment could be damaged, and a bit of trick was needed.)
Since 2 pieces do not enter, I thought that it would be even better if it was sold at about 100 yen per piece.
(This is what to say to Panasonic)
It is used to remove the outlet plate and single wire.
On 2017-08-16 23:25:08
Since the tip is rounded, it is effective in detaching a resin outlet plate that is easily scratched.
On 2017-08-06 14:49:14
You can work more easily than removing the appliance with a flathead screwdriver.
Also, it was possible to remove it without scratching when removing the plate! !
Power supply construction
On 2017-07-27 14:46:24
Although it is a small thing, it is still a special tool. Especially when removing the outlet plate etc. close to the floor surface, I feel that workability is much better than the minus driver.
Type II Electrical Engineer Practical Examination
On 2017-07-05 14:20:15
Until now I was using a flathead screwdriver · · · It was noted that it was marked as much easier to use than the minus driver actually when others tried it, so I tried purchasing it ...
It was good to purchase it very easy to use.
If you try it you can not release it
On 2016-11-17 20:24:42
I thought that a flat-blade screwdriver was enough, but when I tried it it was very easy to use, I wanted it and bought it. Of course you can use it for removal from the mounting frame, but it is handy when you pull out the VVF cable stuck in a switch or an outlet. If you insert it deeply, you dig into it firmly and you can work with it with both hands as you can release your hand firmly. The tip is rounded so it will not get scratched.
When removing the plate
On 2016-08-27 01:37:34
It is useful for removing from embedded switches or outlets. Although it may be a flathead screwdriver of 5.5 mm separately, there is a feeling that it is easy to enter because the tip is rounded. Although it is a set of two, it is good to use it after dividing it one by one because another one is an obstacle when used as it is.
Indoor line construction
On 2016-02-29 22:36:17
It is handy to remove it even if the cable inside the Box is short at a small repair site etc. Although it is a special tool, the number carried around increases, but it does not matter because it can be done with the key
Removal of embedded switches and others
On 2014-02-28 19:34:54
Up to now it was a minus screwdriver to remove the switch from the docking frame, but especially in the Cosmo series removal from the front seemed to hurt the switch. Removal from the front was made smooth smoothly by using the plate removal key. Of course, removal from the side and removal of the cable can be done smoothly. After all the dedicated tool increases the portability, but it is easy to work accordingly.