The reviews are automatic translation.
To the maintenance of the motorcycle
On 2018-01-26 10:53:23
Looking at the reviews, use for motorcycles stands out, but I also use for motorcycles.
I changed the mounting bolt of rusty muffler to this stain bolt. It is in the lower part of the car and it is very nice as an exchangeable bolt which is easy to rust with heat and water. In many cases there are places where it is difficult to work, with flanges still better to eliminate the work of biting washers.
Used for parts visible from the outside of the motorcycle
On 2017-12-02 08:36:30
this is good! Used for caliper mount. I think that there are a lot of areas to hold down on looks as well. I will gradually replace it from cap bolt here.
On 2017-06-28 09:21:32
Although genuine iron bolt rusts immediately, it can maintain its good appearance because it does not rust, it is saved because it can be purchased from a small amount.
Motorcycle parts stopper
On 2017-06-09 09:10:10
Floss stone montalow Looking for flange socket I found It is used to stop the brake rotor of the motorcycle Appearance is also GOOD.
On 2017-05-27 10:55:33
In the information on individual products, since there was no "l" sign in the notation of "length", I judged that "length" = "total length" and bought it. However, because "length" = "l", a product that is too long has arrived. The notation of the displayed drawing and the state where the explanation is incorrect are the sources of mistake. Moreover, I think that "page thread" and "half thread" should be made in such a page layout that the photograph and the product match. I hope you improve the notation.
Motorcycle parts installation
On 2017-04-11 19:02:12
I used it in a place prone to rust but I was satisfied without any problems
On 2017-02-09 15:34:49
Replace the washer with the replacement hexagon socket with the bolt where there is, the on-board tool can be small
Fastening of motorcycle to aluminum alloy part
On 2017-02-03 20:54:52
I think that it is less likely to hurt the tightening surface because the seat surface is circular and wide. At the same time I think that it will prevent loosening from collapse etc.
Fixing the motorcycle disk
On 2016-09-20 17:23:12
Although there are slight variations in the accuracy of the flange part, it is inexpensive to use without problems, good
When replacing parts
On 2016-06-19 05:52:47
I was searching for a slightly looking screw that changed and arrived. Since it is a flange bolt, it can be tightened securely. Although it is obvious, it is unsuitable for mounting aluminum parts.