Bolt replacement of furniture
On 2016-12-14 20:14:30
(Not the course propaganda, for the reader's reference, amissing) favorite to have Muji made hexagonal hole of the bolt that secures the shelf plate of the unit shelf of the scallop is will collapse from carelessness, this is a screw Zaurus as remove some day, I was looking for a replacement because any replacement is required.
Standards of this bolt is, why ordinary things ISO (metric thread), not, UNC is (Unified coarse of screws) (,,, I wish to adjuster bolt is a M8 of ISO).
Nominal diameter of the screw is # 10, a length of 5/8 inch, that is # 10X5 / 8 in the correct bolt, yet is low head, but you need the stainless steel, if possible, not of course this niche ones in the home improvement it is not.
Again from these things it is easy to see the list, is welcome as always from the viewpoint of Tanomeru of shipping and labor along with other products.
And, it was purchased to determine while comparing the hand of the screw and ruler and the screw standard table, fortunately correct answer.
However, since the unit shelf original bolt is a flanged I ready-to-use to stop the shelf, as long as this product is flange there is no (low head stainless unified screw with a flange that was checked on the net, also are not commercially available unfortunately required) so, so as not to sink into the head to fool hole, and it should always bite the washer.
Washer there is no person Let's buy here. After, so small 3.5㎜ than the size of the hexagonal hole the original (width across flats width 4 mm), do not forget also ready for hexagon socket wrench. Well would you already have if the person who is looking at this, but ....
Maintenance of the tape recorder AG-440B of the US-made AMPEX
On 2016-08-03 17:13:57
Always new bis is when basically assembled after overhaul
So you use a little rust on the old screw has occurred new
The screws are all stainless steel.
Purchased screw this time accuracy strength is also a big satisfaction.