The reviews are automatic translation.
On 2017-11-23 16:59:44
The accuracy of the pla parts is low, male and female do not fit. I tried hard for about an hour, but I could not use it after all, it seems that I abandoned money, including time labor as well as parts bill. Even if it is a PB product, it is terrible. I should have made it to a maker item.
Preparation of sample items
On 2017-11-07 14:42:17
I was worried a bit because there was no manual, but I could use it without problems.
On 2017-11-07 08:43:08
Because it is cheap, we are ordering a few items so that it becomes free shipping and other products.
Motorcycle Electrical system wiring
On 2017-10-30 14:38:50
I bought it because I wanted to change the light system wiring of the motorcycle.
Looking for a housing on the female side that matches an existing wiring connector
I thought that it was probably the female side of the same housing type
It was of the same type as expected.
It was saved.
On 2017-09-30 12:06:50
I used it more than before but there is no problem
There are also necessary things such as reworking compared with first-class products.
Connector replacement / wiring connection
On 2017-08-04 14:51:20
I think that it is inferior to a certain maker item.
There was a thing that I did not make it a little somewhat when connecting.
So ☆ three ...
Used for speaker wiring of component
On 2017-07-02 19:08:24
I used it in the middle of wiring when installing the component's speaker away from the main unit. I failed to crimp a few terminals during wiring and ran out of the terminals purchased in spare. This 110 type terminal is smaller than the usual flat type terminal and it can not be obtained by the neighboring home center with individual terminal, so it is appreciated if you sell things with only terminal 50 or 100 sets. There are many things that fails crimping because the size is smaller than the things you normally use. Currently only the set terminals are exhausted and there are only three sets of things left in the harness part, Yes. I think that the goods are good products without any contact failure.
On 2017-06-18 20:48:14
I used it to install a voltmeter. I think that's enough.
Wiring work of automobile electrical components
On 2017-06-08 19:56:18
You can not remove it by pushing the coupler all the way in. There is a problem with the terminal when trying to confirm by destroying. It is good that the hole of the male terminal and the convexity of the female terminal are fitted together, but it is fitting hard enough that it can not be removed with bare hands. I purchased 4 sets, but they were all in the same condition. I hope improvement.
Power connection for amateur radio equipment
On 2017-05-22 23:20:24
Please show how to insert metal terminals, because that is easy to understand.