On 2017-01-11 11:29:58
W used when too ledge in the nuts and nylon nut, but from the price is high nylon nut, was very good because the fit to the size you want. Can tighten the comparatively smooth, moderately difficult to loose feeling that tension is applied. It may be hard to rust in stainless steel. Other than M6 better if it is possible to provide cheap in several 1 pack.
Loosening of the high-speed rotating body
On 2014-04-25 13:48:01
Radio-controlled helicopter, and the propeller for a fixed rotating at a high speed, such as multi-Copter,
We wanted to do a solid loosening.
Assembling the motor and propeller, loosening was easy to occur in the specified nut.
It becomes heavy when you double-nut, also in the'll use two thin nut, thin nut early
Not on the market.
Was purchased U nut with the intention of evaluation, fine-tightening is tight, loose prevention is achieved.
It can not even be temporarily tighten at all in the fingers.
However, since the soft in the bolt side of the material made of aluminum-based, threaded scraped.
It is what happens a few times, and to desorb the nut, unconfirmed.
For now, this is a nut that seems likely to be used. Currently, in the long-term monitoring.
Stainless steel has a high price, but to make good.