The reviews are automatic translation.
CBR 250 RR MC 51 drive sprocket nut
On 2018-05-19 14:18:16
CBR 250 RR MC51 Used for drive sprocket nut.
I exchange frequently, so I regularly exchange it for a new item
Since the size of the head is 14 mm for genuine 17 mm
Since there is no serration, the base material is not hurt.
For motorcycle maintenance
On 2017-08-29 08:31:30
Things that are 14 mm at M 10 can not be obtained at home centers
It was saved.
Address V 125 G as front axle nut.
On 2017-06-12 20:47:13
I bought it as an address V 125 G front axle nut. I could install without any problem. I could not get it in the neighborhood home center but it seems to be able to exchange every time I remove it.
On 2016-12-12 19:25:38
Although it is cheap and good, it is regrettable that the thickness of the nut is small.
For tightening important parts
On 2016-08-28 07:08:01
Once we assemble it we use it in areas where it is difficult to tighten further. There is neither possible nor impossible, it is very ordinary. I would appreciate it if the price goes down a bit if I say it.
With maintenance of mopeds
On 2016-08-10 16:51:34
It seems to be the same type as the rear wheel axle nut of appearance, moped (MOTOCOMPO)
On 2016-04-27 10:21:01
I also searched in the home center, but I could not find it and ordered a motorcycle shop too cumbersome. It is very beautiful and satisfied than the image. It is also appealing to sell by subdivision.
L600S Move's stabilizer bush mounting
On 2014-08-15 13:33:10
It was quite a size (pitch was fine) for home improvement, but it is perfect. It is saved because ordering genuine products is troublesome and expensive. There seems to be an effect to prevent loosening.