The reviews are automatic translation.
Axle shaft nut stop
On 2017-03-05 14:57:04
Although the split pin is attached to prevent the rotation of the axle shaft nut of the motorcycle, it is not good to recycle once removed. I thought, purchased with the intention of not being expensive or disposable. Because it is easier to bend than stainless steel, you do not have to worry about breaking. Since there are so many we can not use it even if we change it every time we remove the wheel such as exchanging tires.
Fastening the screw of the rotating part
On 2017-03-03 15:56:23
The product is satisfactory. However, because I did not understand the detailed size of the original part, it was different in size, so it is saved if there are things like a trial set that have a few size differences in a couple of them.
During snow removal machine maintenance
On 2017-01-26 14:53:53
Things are good, but I purchased it due to size mistake. I would appreciate it if you write the nominal diameter and the actual size.
Repair of construction machine cylinder
On 2016-08-25 19:16:23
It is necessary because it uses quite a lot in the cylinder of the old machine. There is no problem at all.
On 2016-06-25 17:56:15
Good at low price
Honda Acty HH 3 Looseness of rear wheel hub nut
On 2016-04-20 14:38:16
Although it is a small item, I can not remove the drum without this part. It is cheap and saved. Since it contains a lot, it is all you can forget from now on.
To fix the Yamaha mate's tire nut for postal payment.
On 2016-03-31 15:40:39
I was looking for this size of chrome. Although it may be taken as a regular part, in the snow country, since the winter tire is exchanged for winter tire, summer is replaced with summer tire, the split pin is very worn out.
When attaching the rear wheel of the motorcycle
On 2015-03-01 16:41:14
Because it is cheap, we do not mind even disposable use without reusing.
On 2015-01-28 20:52:55
Because it is a plating split pin, it expects rust prevention.
Where to use split pins
On 2014-02-27 00:41:34
It is slightly higher than non-plated, but I think it's hard to get rusted