The reviews are automatic translation.
Cut surface molding of the aluminum plate
On 2016-08-22 09:40:19
Well off, sharpness has sustained.
On 2016-07-15 16:05:31
Cheap but the best! Nashi no problem if the plastic processing!
When machining a hole in the aluminum plate
On 2016-07-10 10:56:07
Precisely because the can be processed a hole in the aluminum plate, we are satisfied.
On 2016-06-07 23:20:50
Pressure is also not even impossible
Surface processing before shed center drill on a lathe
On 2016-05-01 21:08:28
It is used to clean the surface of the part that hits the center drill in the end mill when there is pretty awful end surface state of the cutting material when using the center drill on a lathe. The item is satisfactory in all aluminum, brass, iron.
Production of the model
On 2016-04-07 14:44:04
It uses mainly brass, to the cutting of aluminum. Bali has been satisfied without any can be cleanly cut.
Use in woodworking work tenon cut
On 2016-04-06 07:38:18
Pine laminated wood to the material, was used to Hozokiri for the pointing finger sets of joint.
Like the number of revolutions of the router is too fast, it had caused the seizure.
The woodwork, it seems two blade than four blades was good.
On 2016-03-29 16:10:41
Probably the milling machine is not good that you own. Sharpness is impressive that does not last long.
Cutting of 10mm aluminum plate
On 2016-02-08 17:47:01
On 2016-01-12 16:39:27
It was shaved very well After cutting the wood.
Metal have not tried that yet.