The reviews are automatic translation.
On 2017-01-31 02:46:57
Cheap in price, you can use not the same as other manufacturers.
Repeat is a commodity.
Cutting in the milling machine
On 2016-02-28 22:00:16
Price is cheap is good. Buy continue.
On 2016-01-13 14:49:41
On 2015-12-09 21:42:25
Second time of a purchase
It does not overshadow any to still stable well-known manufacturers goods cutting ability and durability
Is an excellent as well as of the brazed byte chip
It will continue purchase
Cutting (medium minced-finish)
On 2015-09-17 22:22:16
Company M and T's standard products and feel of, finish, there is no comparable in durability
Those who wear has been re-used as a low with byte chip but
There is no change in the performance to put the or low is good heat resistance
On 2015-09-06 16:01:59
So inexpensive we use to roughing-finishing.
On 2015-08-09 11:14:20
SDKN42 is easy to use in low-cost, the other to the SEKN42 you very helpful in terms of cost, if in this series.
Come and ask the market.
I used to cut with a milling
On 2014-11-26 21:50:05
I used to cut with ss41 rough ground in the milling!
You can use enough finish it is also beautiful. Try using any 45c.
Because we used in rough ground chip I had quite lacking. Price is also cheaper than those of the manufacturer
Since the good usability is the future of fun.
SS material, SC material, such as pure iron, mainly plane milling
On 2014-11-07 12:36:59
So far, which was using those of other manufacturers, you can use without inferiority.
When a discount, you have to buy.
On 2014-08-13 13:24:54
Quite good for the price