* Products that meet your criteria are shown in table below.
- Cutting Condition
- Work material: P (steel) ISO f = 0.2 - 0.3mm/rev Vc = 150 - 300m/min ANSI f = .008 - .012 ipr Vc = 492 - 984sfm
- Corner Height Tolerance (mm)
- Hole Diameter d1 (mm)
- Corner Radius rc (mm)
- Thickness s (mm)
- Holes With/Whithout
- Cutting Range
- Fine finishing
- Blade Length l (mm)
- Inscribed Circle Tolerance (mm)
- Relief Angle (degree)
- Thickness Tolerance (mm)
- Inscribed Circle Diameter (phi mm)
- Tungaloy: NS530/NS720/NS730 Kyocera TN60/TN6020 Sumitomo Electric: T1500A MITSUBISHI: NX2525/NX3025 Sandvik: GC1525/CT5015 Hitachi Tools: CZ25 die Jet: CX50/CX75 Isukaru: IC20N/IC30N/IC520N/IC530N
- Work Material
- P (steel) / K (cast iron)
- Equilateral triangle 60 degree
- MNP30 (cermet)
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
8 Customer Reviews
The reviews are automatic translation.
On 2016-11-29 17:05:39
It shaved anything rather tentatively selected the material did not become a shiny.
Outer diameter machining by lathe
On 2016-08-14 18:05:37
I think that it can be used unchanged and those of other leading manufacturers.
Purchased for father
On 2015-12-18 19:25:40
Do not get price increases
SPECIAL tool policy with the auto repair
On 2015-09-28 13:46:47
Since the time of this order is our work does not mean there to know in detail the lathe
Holder - and the chip fit can not and do you have or for example medium chestnut as can be seen in the amateur
Parting, other drill bit holder - such as
Sharpener outside 径削Ri, short surface
On 2015-09-18 16:29:56
Although no cuts in the outer diameter and a short surface and shallow problems, that's about 2.5mm, it can not be used at all missing blade to the back surface
Cutting of SS bars.
On 2015-04-26 19:33:07
Although it dropped by a single-function board the bars of φ17 to φ15
Sharpness, surface roughness is good gloss does not go out too much
Durability seems good.
I would also like to use to continue next time.
Ordinary lathe work skills test
On 2014-08-24 04:08:35
The outer diameter of the wood species MNP30 normal lathe work primary, end face, was used in the outer diameter of the tapered portion finishing.
Drawings finished dimension is φ40 or more points is the main spindle rotation speed 1000 rpm, less chose the 1500 rotation.
Finishing allowance sends in 0.2mm is 0.1mm. Cutting oil did not use.
Place finish dimensions φ40 ~ 60 was able finish shiny filled with surface roughness.
φ40 or less came out the surface roughness, but the gloss was not good enough. (Lack of speed)
The basic performance meets. Price is also good cheap.
On 2013-04-23 14:29:22
Not yet been used. It is preliminary.
Customers Who Bought This Item Also Bought