The reviews are automatic translation.
Maintenance of motorcycle
On 2018-02-15 17:40:34
Although there are also in other reviews, I want improvement because the connection part is grazing with one bolt and stability feeling is bad. Moreover, it is not possible to use it depending on the car type and the tire because there are not too much height.
Maintenance of the motorcycle
On 2018-02-09 15:08:07
It was easy to assemble and the workability was good.
I thought that if there was a stopper made of rubber on the opposite side of the wheel of the stand when using the stand.
On 2018-02-01 18:17:34
GSX 1300 R, car verification weight 260 kg, rear axle load 130 kg Used.
Although there was also a very bad evaluation, purchased with no good.
As the instructions stated, since the self-lock nut of the connecting part was fully tightened, there was no rattling of the motorcycle at the time of using the stand at all.
If you do not tighten the screws tightly in the instructions, it was written firmly as it causes causes such as rattling, so if you get rattling, it may be that the screw tightening is insufficient.
Honda (Naked) 750 cc, (American) 250 cc both when maintenance
On 2018-01-11 08:45:43
We were able to use both Honda (Naked) 750 cc, (American) 250 cc ... It was cheap, the pipe was also thick and good shopping. Compared with other companies' products, the price setting is really reasonable!
For motorcycle maintenance
On 2017-12-31 22:56:28
You need a knack, but if you get used to it, it's user-friendly.
It is essential for vehicles without a center stand.
It is convenient to have it for vehicle storage.
On 2017-12-27 17:41:54
Used in Aprilia 1000 cc (Equipment weight 210 KG). I was concerned about insufficient strength, but when I tried it I lifted it up without any problems. Although I tried shaking it was not a solid sense of intensity, but I never felt anxiety. However, the width of the size was full and it was not possible to use the attached stand hook. I was able to use the V Hook on hand so I exchanged it. V hook could be used by a straight tool shop. Because it is narrowed from the hand slightly towards the tip of the stand (about 5 mm), if it spreads by force technique it seems to be a little easier to use. It can be disassembled and the price is also cheap so it is not a problem if it is at the Sunday Mecha level. Moreover, it seems to be good as the material of the original stand production.
For chain maintenance etc.
On 2017-12-26 16:04:02
In the review there were both pros and cons, but it was inexpensive so I bought it
I feel uneasy about the strength of the whole pipe rather than the connecting part, but if you think about the price
It was inconvenient for the part receiving the swing arm to be reversed by its own weight than that
Although it seems to be understood if tested before release ...
It will be used for motorcycle parts replacement, maintenance
On 2017-12-25 14:11:44
I used it for the rear suspension exchange of D tracker 250 this time. I used the stand for the first time, so I do not know about other stands. I do not think that it is tough on that, but it never broke soon. I am satisfied that I get a motorcycle stand at this price.
Using KSR 2
On 2017-12-23 00:37:44
Because it corresponds to the width of the swing arm for the price, it is saved because the corresponding vehicle is wide.
Maintenance of the motorcycle
On 2017-12-19 20:52:44
Although the price is cheap, uneasiness remains in the strength of the main body. It is likely to deform when straddling the bike. People who can weld seams are five stars.