Although it is a point to wear, in order to install this part there is not a certain clearance between the slide door and the pillar and it can not be installed unless it is processed I think that it is good to display the dimensions of the product at the time of sale This construction Clearance of the vehicle that was made 10 mm Normally mounted clearance not enough to process the door pillar and then install it from the inside but install wiring with Giboshi but caused contact failure Solder the wiring directly to the terminal as a solution did
Minicab club plastic so easy to process. Once you have determined the position of the hole, just install it. no problem. Since the attached Giboshi is worried about loosening, the female terminal was squeezed.
The size of this part is different between the door side and the car body side. Although I think that there is no particular problem when installing new, I (Subaru Sambar) comes with a dummy slide adapter in advance, and processing of parts screw holes is necessary to use that screw. Otherwise there is no particular problem.