The reviews are automatic translation.
Nail exchange of tractor
On 2016-12-23 18:52:55
That I bought a set of another replacement nail for the tractor of previous Yanmar, since the returned goods not match Upon cover, but I bought two on both sides of the eccentric just to be sure, and do not enter in thick on the mounting portion, this time the was also mounted by cutting a grinder Upon cover. But cheap is good, I just question whether the suit in price when it comes attached shaved all.
Standard use dry paddy field / paddy plowing
On 2016-04-12 19:57:19
For Henshintsume confirmation in this 46829903 is for the right mounting tractor manufacturer
Set Once you have the image attached to the Routari of Fukuno of his office in reference to a change in the code to reference another site when that will try but one side order are supported that was mistake twice in order Henshintsume I want to raise the intensity at the same thickness as the genuine products that will interfere with 0.2mm for the mounting portion I was cracking in the mounting hole I think thin minute weak
Replace the nails of tractor
On 2016-02-09 19:26:03
But always it had been purchased from the tractor distributor
I worried whether fit the mounting opening
Problem is, there was no
Product Description was also satisfied
On 2016-01-19 09:35:20
Nail is somewhat too long because it was against the faint to the rotary of the case, was attached by cutting the tip in the grinder. However, it positions you can put up with so was able to buy enough cheaply. And some models, you can not even that would hit the case as their own.
As tractor exchange claw
On 2014-10-21 11:42:50
I think the price may have been suppressed.
On 2014-10-16 20:56:54
It uses as a tractor exchange nail. Cost performance is very high will buy next time.
Used Kubota tractor
On 2014-09-11 14:53:52
It can be used in tractors or Henshintsume single purchase of ownership. Henshintsume thickness width of common nails and mounting portion was the same. Henshintsume holder is usually nail holder than the width, (fill plug the nail and the holder of the gap in the iron plate, etc.) processing required at the time of mounting due to the large thickness eccentricity dimension was not almost the same as the name brands. The length of the nail is short about 2cm at the tip. Usually nail be purchased and then try to use.
Kubota KB20 tried to use the rotary RSP13K
On 2014-07-13 22:07:43
Attachment was possible but was not available there are per what was different eccentric dimensions
Of field paddy Okoshiko
On 2014-06-08 10:00:16
Even without the limitation of the machine can be mounted, Okoshiko condition is good.
On 2014-06-03 12:34:25
I bought so that with the corresponding to most of the models, but it does not work would interfere with the rotary. To buy only described or one of the corresponding model requires measures such as confirmation.