I was expecting that the mounting bolt was too long or the rubber collar attached was unknown, so I was able to adjust it with a bolt and collar that we had and it was possible to install it as smoothly as possible. Even so, the supplied bolt is too long.
There is nothing wrong with the left grip end, but since there is an accelerator grip on the right, this product expands the expansion rubber for fixing near the end, so resistance will be attached to the rotation of the accelerator as you tighten it. I had no choice but to handle 2 pieces of aluminum pieces 2 mm thick on the outside according to the inner diameter of the handle pipe, so that the fixing rubber would expand in the back so as to avoid interference. I think that it will be a good product with a slight design change. I will expect it for each motorcycle rider.
Although alumite is covered beautifully, there are some coarse cuttings, and we dealt with it by setting it in a place difficult to see. I am satisfied if I consider the price. Exchange with genuine bar end. Since the weight remains Honda genuine, it is a type with cutouts, but since this item is a completely flat bottom, the clutch side is as it is, the accelerator side inserts a washer prepared separately and creates a gap between it and the grip Did.