The reviews are automatic translation.
Used to process additional holes of BOX
On 2018-04-14 12:34:57
It is used for hole processing of control board and relay BOX. It is re-purchase.
In the past I was using carbide chip things, but I was looking for sharp items to use charging impact drivers, charging driver drills etc.
Using carbide tip type, bimetallic type few teeth, bimetal type large number of teeth (this type), it is sharp and rich is also good. It is not inferior to other manufacturer's products.
Because continuous heating is concerned about heating, there are things that do more than 10 consecutive machining while replacing 2 to 3 pieces, but there is no problem.
If you use it on a thick steel plate that has a thickness of 5 mm or more, the tooth will be gone, but if you do not mistake the place to use it has quite a bit.
The carbide chip type is noticeable if it lends to others, damage of the chip is conspicuous, but this product seems to be less damaged.
With several pieces of machining, machining time becomes short with high speed rotation, and the cuts seem to have less burrs than others. It seems that burrs are further reduced if it rotates at low speed.
Even my colleagues will come up well if it makes a hole easier than a carbide type. I am using the same size difference.
Drilling to pass wiring through aluminum
On 2018-03-14 14:58:37
Excellent sharpness because the blade is thin. It was quite long lasting. After that I want you to increase the type with a little more depth than the diameter 12.
Angle when drilling
On 2018-02-27 11:23:38
Too much wasting (^ ^ ;;
And it is hard to put in bit (* _ *)
On 2017-12-05 08:57:46
Although it can not be helped sharpness becomes worse if it is used several times, it is earlier when the sharpness becomes worse when compared with the commercial item.
When drilling a box
On 2017-09-07 20:39:58
It is very sharp. In the case of plastic, the material hollowed out in the hall remained, but when I used cutting oil, it got cleanly dislocated.
Steel, board drilling
On 2017-08-12 22:24:36
Previously, I used only heavy-duty horn saw. Quality and durability were good. When thin blade halso comes around and purchases it on trial, we can drill quickly, so we tried using a variety of makers' thin blade halso like high price cheap. As a result, exhaustion is pretty fast, thin blade Holly saw should be cheap. Just buy it again if you do not do it. If you are looking for precise quality and durability you can buy something like that. We have reached the conclusion. Buy with Ripi.
On 2017-07-23 13:08:08
Sharp durability is also good
It is Ripi goods every time. It is still better if it is a little cheaper.
Drilling of artificial marble
On 2017-05-20 17:04:09
Drilling epoxy artificial marble. Especially it was able to be used without problems. It is good to cut this well.
Drilling of a sink or the like
On 2016-12-12 10:06:29
The blade also thinly cuts cleanly. Cospa best. There are many comments such as not being a true circle, but the way of saying is bad, but after all it is a cheap product. People seeking a moderate finish can buy top-notch brand items.
Drilling in a pool box or board with an electrician
On 2016-11-09 21:24:19
I have not used it yet, but it looks quite a circle and its quality is low, I will probably not buy any more. Size 22 is not worrisome, but as it grows to 27, 33, it gets worse, it is the worst because I bought it.