The reviews are automatic translation.
Drilling of the operation panel
On 2016-10-03 05:10:45
Used to make a hole in the control panel of the iron plate.
As of the item description, the front and back of the burrs are less finish clean.
Iron, stainless steel drilling
On 2015-11-27 23:16:42
It is clean drilling. great.
Drilled small holes in the stainless steel
On 2015-04-27 09:33:15
Buy 10mm, 12mm, a 15mm three kinds of for the drilling of stainless steel.
Holsoe that Sten correspondence with a small diameter is, I'm glad I was in did not find a quite handy.
Angle drilling, etc.
On 2014-11-27 14:36:29
Is 2 repeater.
It is the best and eliminates the need of the Bali process.
Drilled bolt holes
On 2014-08-28 17:15:33
It is for thin, but it is used to 3.2,4mm.
Bali has been less very useful.
Broken After also plans to purchase.
Because it took quite a time to arrive from the order, it will be saved to fall into the hands in the five days position.
Bolted to open a hole in the thin iron plate.
On 2014-08-28 11:32:53
Blade in the second perforation is hesitant to use because missing one.
Use the SUS plate, or the like
On 2014-07-10 21:59:10
It is the best in the drilling of the sheet metal. Clean is also less durable Bali also, you can use without any problem to be even how to use, such as prying. Centering to a cutting oil a little, the rotational speed is low, and use not apply too much force, not parted. The drilling of thin plate, without those out on this right!
Drilling of the mild steel material
On 2014-04-21 23:34:54
But was the drilling of 3.2mm of iron plate was able to drilling without putting the well too much force sharpness. Because it does not escape luck Unlike normal drill (Kiri) after the hole is open I think that is a good place that can work safely. Positional shift if drilling from hitting the punch also will be drilled holes without. Center pin is OK only in the punch because the sink in the spring.
Processing of aluminum material
On 2014-03-28 15:45:28
Holsoe seems to be long-lasting if the work left to the sharpness without putting too much force.
We're using the things of the various manufacturers until now
This product is also excellent sharpness, I also like that the burr does not come out.
We want to align the Holsoe of each size in this series in the future.
Used in drilling of duct rail and rack
On 2014-03-07 20:30:48
I purchased for bolt drill holes, center pin shift the workpiece and the center pin is pressed against the Horukiri because it is not a drill will be scratches.
I think it is good that can be used in the charging drill, but it is difficult to mastering. (It seems impossible in the amateur!)
Chips will be the round rather than the chips, such as the 5-yen coin "○" chips.
Kiri of sharpness I think that there is no perfect.
The uses though, and may be good if you use any of the things that may be made to the drilling and scratches at heights.
To buy again is pretty subtle.