- Tip is sharp and dangerous. Be careful to use.
- Substrate process and point scribing during sheet iron drilling work.
- Body: brass
* Products that meet your criteria are shown in table below.
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
4 Customer Reviews
The reviews are automatic translation.
Mark for the sign attached
On 2016-11-16 15:33:25
With one hand, OK, so efficiency up! It does not come off, most aimed at the place.
Control panel of drilling
On 2015-07-01 08:23:31
Unexploded with a probability of about 10 Hatsuchu 8 shots! Although we had to replace
Also replacement can not be used with a frequency of about the same! !
Or DIY if you forgive for? I
To use in the work force.
... Sell this product in cold blood is
Distrust is there.
Now, since I bought the third-party products,
It was disposed of.
Do not buy again.
As punch mark for the lower hole of the control panel
On 2015-05-13 14:18:09
5/13 arrival in the afternoon. We used immediately, but the punch operates five times and subsequent ratchet (caught operation) does not working. Although tried the strength adjustment is unchanged phenomenon.
It is a complete failure goods. It is the question whether sells confirms the operation. I was planning to use from today, but it is planning changes forced changes that much 500 locations. Only stood about arrival to 20 minutes. How do you handle that say MonotaRO dono! !
Position of drilling together
On 2014-11-12 15:16:14
There is an empty beating about once every five times. When I strike normally it is not particularly dissatisfied.