Handmade Sticker Labels
- Label Thickness (mm)
- 0.10 (protective film / 0.05)
- Surface Mounting
- Standard Overall Thickness (mm)
- Polyester film
* Products that meet your criteria are shown in table below.
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
4 Customer Reviews
The reviews are automatic translation.
On 2017-05-15 10:09:29
We print our logo and paste it on equipment etc. It prints beautifully and lasts because it forms a protective transparent seal on the printed surface. I think that it is enough if it creates a small sticker, because it is metal so it looks good.
It is very convenient to seal print.
On 2017-02-08 22:18:57
Because it does not print fell, easy-to-use. Thank you very much.
Paste to the car body
On 2017-02-06 13:17:14
And make full use of illustrator and plotter, will create an shall not be inferior to commercially available stickers.
Out ... it is, in one shot when caught in the rain. Sticker of penetration 100% moisture from the cut surface of the deep, bleeding of ink, clouding of stickers will always occur. Sing the water's the goods, but it was disappointing products that disappointed with is this supposed When you swallow.
Used in the fabrication of the motorcycle of caution label
On 2016-07-27 17:12:26
The use of the ink-jet printer was good in print. Pasting a transparent film is required technique (practice). Ease of use of dedicated software to be downloaded from the HP (Nixa) has room for improvement.